Danby DPAC8KDB - Dehumidifier and Drain Hose Installation; Dehumidifier Mode Operation; Installing PVC Drain Hose

OPERATING INSTRUCTIONS (cont’d)
DEHUMIDIFIER
Note: During dehumidifier mode, the exhaust hose does not
have to be vented outdoors.
1) Press the CD POWER SWITCH key (Fig. G) to
switch the unit on.
2) Press the MODE key (Fig. H) until the DRY
indicator light illuminates on the control panel
(Fig. I). Each depression of the MODE key will
advance to a different mode setting (CoolO-
DehumidifyO- Fan • - Auto AUTO)
3) If the room temperature is > 25°C (77°F), fan
speed can be adjusted. Press the FAN key (Fig.
J) to select the desired FAN SPEED setting. Your
selection will appear on the control panel. Each
depression of the fan key will advance to a
different fan speed (High lii*- Med.u*- Loww)
as shown in Fig. K. Otherwise fan speed is fixed
lmportant:The garden hose must be
installed during dehumidifier
f| mode
When using the continuous drain function, the PVC hose
must be placed horizontally below the drainage hole.
Avoid uneven ground and folding the hose.
NOTE: Should you damage or misplace the pvc drain hose,
a standard garden hose can be used.
INSTALLING PVC
DRAIN HOSE
9