Danfoss 5000 Flux - Parameter List

MG.90.D1.02 – VLT is a registered Danfoss trademark
40
VLT
®
5000/5000 Flux/6000 HVAC/8000 AQUA PROFIBUS
■ Parameter list VLT 5000 Flux
PNU Parameter Factory setting Range Changes Conversion
# description during Index
operation
200 Output speed Only clockwise, No Yes
range/direction 0-4500 rpm
201 Output speed low limit 0.0 rpm 0.0 - n
MAX
Yes Yes
202 Output speed high limit 30000 rpm n
MIN
- par. 200 Yes Yes
203 Reference range Min - max Yes Yes
204 Minimum reference 0.000 -100,000.000-Ref
MAX
Yes Yes
205 Maximum reference 1500.000 Ref
MIN
-100,000.000 Yes Yes
206 Ramp type Linear Yes Yes
207 Ramp-up time 1 Depends on unit 0.01 - 3600 Yes Yes
208 Ramp-down time 1 Depends on unit 0.01 - 3600 Yes Yes
209 Ramp-up time 2 Depends on unit 0.01 - 3600 Yes Yes
210 Ramp-down time 2 Depends on unit 0.01 - 3600 Yes Yes
211 Jog ramp time Depends on unit 0.01 - 3600 Yes Yes
212 Quick stop ramp-down time Depends on unit 0.01 - 3600 Yes Yes
213 Jog speed 200 rpm 0.0 - par. 202 Yes Yes
214 Reference function Sum Yes Yes
215 Preset reference 1 0.00 % - 100.00 - 100.00 % Yes Yes
216 Preset reference 2 0.00 % - 100.00 - 100.00 % Yes Yes
217 Preset reference 3 0.00 % - 100.00 - 100.00 % Yes Yes
218 Preset reference 4 0.00 % - 100.00 - 100.00 % Yes Yes
219 Catch up/slow down value 0.00 % 0.00 - 100 % Yes Yes
221 Torque limit for motor mode 160 % 0.0 % - xxx % Yes Yes
222 Torque limit for regenerative operation 160 % 0.0 % - xxx % Yes Yes
223 Warning: Low current 0.0 A 0.0 - par. 224 Yes Yes
224 Warning: High current I
VLT,MAX
Par. 223 - I
VLT,MAX
Yes Yes
225 Warning: Low speed 0.0 rpm 0.0 - par. 226 Yes Yes
226 Warning: High speed 100.000 rpm Par. 225 - par. 202 Yes Yes
234 Motor phase monitor Enable Yes Yes
235 Phase loss monitor Enable No No 0 5
0
-1
-1
0
-3
-3
0
-2
-2
-2
-2
-2
-2
-1
0
-2
-2
-2
-2
-2
-1
-1
-1
-1
-1
-1
0
5
6
6
5
4
4
5
7
7
7
7
7
7
6
5
3
3
3
3
6
6
6
6
6
6
6
5
4-Setup
Data
type
Parameter list