Danfoss – 39VUBMA102
7 Accessories
7.1 Room temperature sensor
The room temperature sensor is an accessory that is installed in the house in a location where
the temperature does not deviate greatly. It is used to set the desired indoor temperature. In
the room temperature sensor there is a sensor that provides a further value that the control
computer can use when calculating the heat demand.
In the normal mode, the room temperature sensor’s display shows the actual indoor tem-
perature.
The outdoor temperature may appear if both the up and down buttons are pressed at the
same time.
Use the up or down button to set the desired indoor temperature.
If the heat pump has an active alarm the text AL appears in the display.
Contact your installer if you wish to supplement your heat pump installation with a room
temperature sensor, see the ”References” section.
To Next Page
Loading...
Need help?
General