10 Default settings in the control computer
The first column in the table below shows the parameters that can be adjusted by the User.
The second column shows settings made at the factory, and the third column the settings
made by the installation contractor in connection with installation of the heat pump.
Make sure that the installation contractor enters any settings made during installation that
are particular to your heat pump. This will make it easier for you when you make your own
adjustments.
Setting Factory setting Customer specific settings
ROOM 20°C
OPERATION AUTO
CURVE 40°C
MIN 10°C
MAX 55°C
CURVE 5 0°C
CURVE 0 0°C
CURVE -5 0°C
HEATSTOP 17°C
REDUCTION 2°C
To Next Page
Loading...
