Danfoss EKE

© Danfoss | Climate solutions | 2023.07
General guide: Sensor installation
Danfoss 84N365.11
OD
OD
OD
OD
1
/
2
-
5
/
8
in.
12 - 16 mm
3
/
4
-
7
/
8
in.
18 - 22 mm
1 - 1
3
/
8
in.
25 - 35 mm
1
3
/
8
in. and higher
35 mm and higher
Danfoss 84N366.12
Danfoss 60G496.11
Danfoss
84N403.10
D
f
Close to the
evaporator
1
3
2
Evaporator outlet
Conductive
paste
Important Note
• Mount the sensor on a clean
paint-free surface.
• Remember to use heat
conducting paste andinsulate
the sensor.
• For precise measurements,
mount the sensor max. 5 cm
from the outlet of the
evaporator.
Evaporator
Sensor mounting: Temperature sensor
Close to the
evaporator
Demounting :
Step 1: Step 2:
Unplug above shown male connector
Pull stirrup using screwdriver and
remove EKE from rail
AN433741508202en-000203 | 6