To Next PageTo Next Page
Need help?Do you have a question about the Danfoss EKE and is the answer not in the manual?
General| Category | Industrial Equipment |
|---|---|
| Supply voltage | 24 V AC/DC |
| Enclosure rating | IP20 |
| Mounting | DIN rail |
| Type | Electronic Controller |
| Communication | Yes |
| Input | Temperature Sensor |
Illustrates the basic application of EKE 100 in SH control.
Step-by-step guide for mounting the EKE 100 on a 35 mm DIN rail.
Step-by-step guide for demounting the EKE 100 from the rail.
Steps to reset Modbus communication options to factory defaults.
Guidelines for sharing power, backup supply, pressure, and temperature signals.
Table showing pin assignments for various stepper valve connectors.
Details on cable length and wire size for different connections.
Explains how LED indicators represent valve operational states.
Overview of the EKE 100 display layout and controls.
Highlights plastic housing features and safety compliance.
Important general warnings regarding the use and maintenance of EKE 100.
Precautions and requirements for safe installation of the EKE 100.
Specific warnings related to connecting inputs and power to the EKE 100.
Lists available Danfoss power supply units.
Lists available Danfoss temperature sensors.
Lists available Danfoss pressure transducers.
Lists compatible Danfoss stepper motor valves.
Details on M12 cables for connecting valves and controllers.
Describes the EKE 2U energy storage device.
Information on EKA 200 Koolkey and EKE 100 service cable.
