Danfoss Heating
7
GB
4.2 Advanced Programming
Advanced Programming is meant for changing certain parameters
that are usually only set once. Advanced Programming can typically
be made by the installer as part of the system installation and setup.
GB
By pressing ADV (advance), the user can jump to the next event in the
daily timing pro le. If for instance, the user wants to bring on the room
heating immediately whereas the pro le has been programmed to
bring it on in two hours, the user can simply press ADV and the heat
will be turned on.
See the User Guide for normal programming instructions.
To Next Page
Loading...
Need help?
General
