Danfoss FP735Si

Danfoss Heating
11
GB
To access the Advanced Programming follow the steps below:
a) Press and hold PROG and V for 5 seconds.
The display will change to look like this.
b) Press the + and - keys to scroll backwards and forwards between
parameters.
Press the V and Λ keys to change the parameter setting.
The  ashing digits in the center of the display indicate the
number of the selected option. The large characters in the top or
bottom of the display indicate the option value selected.
c) Press and hold PROG until the display
returns to RUN mode.
Parameter setting
Parameter number
7.0 Advanced Programming