9
VIFZA35X © Danfoss 02/2011
1. Remove the Danfoss Link™ RS
front from the back panel.
2. Turn the Danfoss Link™ RS around
so the back is facing you.
3. Remove one of the batteries.
4. Press and hold the button while
reinserting the battery until LED
flashes red (approx. 5 seconds).
5. Replace the Danfoss Link™ RS
front again on the back panel.
6. The Danfoss Link™ RS is now reset.
Factory reset
5 sec.
GB
Installation Guide Danfoss Link™ RS
To Next Page
Loading...
