8
VIFZA35X © Danfoss 02/2011
Adding device
When the RS unit has been
added to the Danfoss Link™
CC Central Controller, a
network test should be
performed.
For more information on
network tests, see the
Danfoss Link™ CC instruction
manual: Configuration 8:
Perform network test.
At the end of the network test you will be informed that the
test is waiting for signal from the RS unit.
Go to the RS unit and press the LED button for 5 seconds to
force the signal.
Max. 1 m
Perform network test
Connection of the RS Room Sensor
to a system is made from the Danfoss
Link™ CC Central Controller.
For further information, see
the Danfoss Link™ CC
instruction manual:
Configuration 6:
Adding devices.
Installation Guide Danfoss Link™ RS
To Next Page
Loading...
