Introduction
(continued)
This increase the base accuracy of the measurement.
The PFM 5001 can be supplemented with an external ther-
mometer connected via a coaxial connector. The tempera-
ture of the working medium can easily be measured by in-
serting the thermometer into the measuring nipples of the
valve, were you normally insert 3 mm measuring needles.
Specifications for valve manufacturers are pre-pro-
grammed in the memory of the PFM 5001.
The autonomous measuring mode of PFM 5001 allows in-
dependent data recording based on a pre-programmed pe-
riod. The acquired data are initially saved in the measuring
unit and can subsequently be analysed in computing unit .
HEC 7
To Next Page
Loading...
