Need help?Do you have a question about the Danfoss SonoSelect 10 and is the answer not in the manual?
General| Type | Ultrasonic flow meter |
|---|---|
| Application | Water flow measurement |
| Communication | M-Bus, Modbus |
| Power supply | Battery |
| Approval | MID |
Describes tamper monitoring, opening the calculator, and reset procedures.
Explains how to identify supply and return pipe installations for heat meters.
Details pipe position and rotation requirements for optimal flow sensor installation.
Illustrates various mounting orientations for the calculator unit.
Provides step-by-step instructions for mounting O-rings and temperature sensors.
Covers general info on communication modules and details for M-Bus and OMS.
Step-by-step guide for installing communication modules and cables, including ESD precautions.
Instructions for replacing the battery, including ESD precautions and reset procedures.
Steps to bleed the system and check for steady flow rate display.
Details how to configure supply/return settings using the service tool.
Illustrates meter sealing points for tamper monitoring and verification.
Lists the IP class ratings for the calculator and flow/temperature sensors.
Visual representation of the meter's menu structure and navigation loops.
Explains the meaning of various symbols and indicators on the meter's display.
Lists and describes common alarm codes and their meanings.
To Next Page