Name: Danfoss TP5001 series
Brand: Danfoss
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Option 34 - Select on/oﬀ or chrono-proportional

This allows the thermostat to be set to run in On/Oﬀ

mode or for a chrono-proportional cycle rate to be

selected. Press + until Option 34 is displayed, use V

and Λ to select required setting.

0 On/Oﬀ

3 3 cycles per hour

6 6 cycles per hour (factory setting)

9 9 cycles per hour

12 12 cycles per hour

Installation Instructions

Option 35 - Set integration time (Option 34 set to 3, 6, 9 or 12)

(seek advice prior to adjusting)

This adjusts the integration time of the PI

algorithm to increase control accuracy. It should

only be adjusted after seeking advice from the

manufacturer. Press + until Option 35 is displayed,

use

V and Λ to select required setting.

2.5 Integration time set to 2.5% (factory setting)

5 Integration time set to 5%

10 Integration time set to 10%

Option 36 - Set temperature override rule

This establishes the degree of temperature override

available to the user. Press + until Option 36 is

displayed, use

V and Λ to select required setting.

Setting 0 No limit (factory setting)

Setting 1 Limited to ±2°C

Setting 2 No override allowed

Questions and Answers:

Need help?

Do you have a question about the Danfoss TP5001 series and is the answer not in the manual?

Danfoss TP5001 series Specifications

General