Danfoss TP5001 Easy Setting Guide

Setting On and Off times:
Instruction
Buttons Used
Screen
Display
To set the 1
st
period of the day ( )
Press the
button
for
5
seconds. Display changes to show Mon, Tue, Wed, Thu, Fri
with the HOUR flashing. Use < or > to set the HOUR of your
first temperature event. Press to make the MINUTES flash.
Use < or > to set the MINUTES.
<
>
Press
and the display will change to show
TEMPERATURE
flashing. This is the TEMPERATURE you want the room at for
the first period of the day. Use < or > to adjust the
TEMPERATURE e.g. 21
o
C. Press to set and move to period
two ( ).
< >
The display now shows period two ( ) with the HOUR
flashing. Use < or> to select the time you wish period ( ) to
start. Press to set the MINUTES using < or > buttons. Press
to confirm and then use < or > to set the required
TEMPERATURE e.g. 16
o
C. Press and repeat the previous
steps to set the period 3 ( )and 4 ( )
< >
Once periods and have been set, the display will change
to show SAT SUN. Repeat previous processes to set the time
and temperature events for the weekend.
< >
Once the temperature has been set for period using
button, the display will revert to its normal operating display
NOTE
: If your unit is set for
24hr programming
,
the display will show Mon Tue Wed Thu Fri Sat Sun during
programming and all days will have the same times and temperatures set. This is changed in the advanced setting,
see the full user guide for further instruction.
Away Mode:
Away mode is used
to temporarily stop the timing functions if
you are away for a period of time.
To enable AWAY mode, press M button and a will appear
in the display.
The AWAY mode temperature is set to 16
o
C by default. To
change, consult full user instructions.
M
To
disable
AWAY
mode,
press and release
M
button
–
normal
programme times are resumed.
M

Danfoss TP5001 Specifications

General

Brand	Danfoss
Model	TP5001
Category	Thermostat
Language	English