Danfoss VLT 2010 User Manual

MG.20.B6.02 – VLT is a registered Danfoss trademark
87
VLT
®
2000 Series
Section 1 Section 2 Section 3
Special conditions
Danfoss VLT frequency converter and CE
labelling
CE labelling is a positive feature when used for its ori-
ginal purpose, ie. to facilitate trade within the EU and
EFTA.
However, CE labelling may cover many different
specifications. This means that it has to be checked
what a given CE label specifically covers.
The specifications covered can in fact be widely
different. That is why the CE label can give installers a
false feeling of security when using a frequency con-
verter as a component in a system or an appliance.
We CE label our VLT frequency converter in
accordance with the low-voltage directive. This
means that as long as the frequency converter is
installed correctly, we guarantee that it complies with
the low-voltage directive. We issue a declaration of
conformity confirming that our CE label complies with
the low-voltage directive.
The CE mark also applies to the EMC directive, on
condition that the instructions given in the manual for
EMC correct installation and filtering are followed. On
that basis a declaration of conformity with the EMC
directive is issued.
To help ensure that your installation is EMC-correct,
the manual provides detailed instructions for installa-
tion. Furthermore, we specify which norms that are
complied with by which of our products.
We offer the filters that can be seen from the
specifications and gladly provide other types of assi-
stance that can help you obtain the best EMC result.
■
Compliance with EMC directive 89/336/EEC
In support of our claim that the VLT frequency conver-
ter complies with the protection requirements for
emission and immunity under EMC directive 89/336/
EEC, a Technical Construction File (TCF) has been
prepared for each model. Such a file defines the EMC
requirements and the measurements made in
accordance with harmonised EMC standards in a
Power Drive System (PDS) that consists of a VLT
frequency converter, a control cable and the controls
(control box), motor cable and motor plus any options
added. The Technical Construction File is prepared on
this basis in cooperation with a duly authorised EMC
laboratory (Competent Body).
In most cases the VLT frequency converter is used by
professionals of the trade as a complex component
forming part of a larger applicance, system or installa-
tion. It must be noted that the responsibility for the fi-
nal EMC properties of the applicance, system or in-
stallation rests with the installer. As an aid to the
installer, Danfoss has prepared EMC installation
guidelines for the Power Drive System. The standards
and testing levels stated for the Power Drive System
are complied with, provided that the EMC-correct in-
stallation guidelines are applied.
■

Danfoss VLT 2010 Specifications

General

Brand	Danfoss
Model	VLT 2010
Category	Inverter
Language	English