Danfoss VLT 5000 Crane Series - Page 78

VLT® 5000 Crane
Programming
743 MECH. SPEED N2
Value:
RPM
✭ Depends on unit
Function:
Set the speed point for power/speed curve at N2.
Description of choice:
This parameter is limited between N1 (par. 741) speed
and output speed high limit (par. 202).
744 POWER AT N2
Value:
kW
✭ Depends on unit
Function:
Set the output power at N2.
Description of choice:
This parameter is limited to be less than or
equal to the power at N1.
745 MECH. SPEED N3
Value:
RPM
✭ Depends on unit
Function:
Set the speed point for power/speed curve at N3.
Description of choice:
This parameter is limited between N2 (par. 743) speed
and output speed high limit (par. 202).
746 POWER AT N3
Value:
kW
✭ Depends on unit
Function:
Set the output power at N3.
Description of choice:
This parameter is limited to be less than or
equal to the power at N2.
747 MECH. SPEED N4
Value:
RPM
✭ Depends on unit
Function:
Set the speed point for power/speed curve at N4.
Description of choice:
The parameter is limited between N3 (par. 745) speed
and output speed high limit (par. 202).
748 POWER AT N4
Value:
kW
✭ Depends on unit
Function:
SetthepoweratN4.
Description of choice:
This parameter is limited to be less than or
equal to the power at N3.
749 MECH. SPEED N5
Value:
RPM
✭ Depends on unit
Function:
Set the speed point for power/speed curve at N5.
Description of choice:
This parameter is limited between N4 (par. 747) speed
and output speed high limit (par. 202).
750 POWER AT N5
Value:
kW
✭ Depends on unit
Function:
SettheoutputpoweratN5.
Description of choice:
This parameter is limited to be less than or
equal to the power at N4.
751 MECH. SPEED N6
Value:
RPM
✭ Depends on unit
Function:
Set the speed point for power/speed curve at N6.
Description of choice:
This parameter is limited between N5 (par. 749) speed
and output speed high limit (par. 202).
✭ = factory setting. () = display text [] = value for use in communication via serial communication port
MG.50.N4.02 - VLT is a registered Danfoss trademark
77