Danfoss VLT 5000 Crane Series - Page 79

VLT® 5000 Crane
752 POWER AT N6
Value:
kW
✭ Depends on unit
Function:
Set the output power at N6.
Description of choice:
This parameter is limited to be less than or
equal to the power at N5.
753 MECH. SPEED N7
Value:
RPM
✭ Depends on unit
Function:
Set the speed point for power/speed curve at N7.
Description of choice:
This parameter is limited between N6 (par. 751) speed
and output speed high limit (par. 202).
754 MECH. SPEED N7
Value:
kW
✭ Depends on unit
Function:
Set the output power at N7.
Description of choice:
This parameter is limited to be less than or
equal to the power at N6.
755 Power Loss N1
Value:
kW
✭ Depends on unit
Function:
SetthepowerlossatN1.
Description of choice:
This parameter is limited to be less than or equal
to the nominal power of the drive.
756 Power Loss N2
Value:
kW
✭ Depends on unit
Function:
SetthepowerlossatN2.
Description of choice:
This parameter is limited to be less than or
equal to the power at N1.
757 Power Loss N3
Value:
kW
✭ Depends on unit
Function:
Set the power loss at N3.
Description of choice:
This parameter is limited to be less than or
equal to the power at N2 .
758 Power Loss N4
Value:
kW
✭ Depends on unit
Function:
Set the power loss at N4.
Description of choice:
This parameter is limited to be less than or
equal to the power at N3.
759 Power Loss N5
Value:
kW
✭ Depends on unit
Function:
Set the power loss at N5.
Description of choice:
This parameter is limited to be less than or
equal to the power at N4.
760 Power Loss N6
Value:
kW
✭ Depends on unit
Function:
Set the power loss at N6.
Description of choice:
This parameter is limited to be less than or
equal to the power at N5.
✭ = factory setting. () = display text [] = value for use in communication via serial communication port
MG.50.N4.02 - VLT is a registered Danfoss trademark
78