Danfoss VLT CANopen MCA 105 Programming Guide

Option
Name
Description
[2]
Commit transaction
Commit all parameters that have been sent during BTM mode.
[3]
Clear error
When parameter 8-46 BTM Transaction Status shows an error (3–8), the parameter must be
cleared by setting this value.
[4]
Write to setup 1
N O T I C E
This option is only available with software version 9.XX.
[5]
Write to setup 2
N O T I C E
This option is only available with software version 9.XX.
[6]
Write to setup 3
N O T I C E
This option is only available with software version 9.XX.
[7]
Write to setup 4
N O T I C E
This option is only available with software version 9.XX.
[8]
Cancel BTM transaction
N O T I C E
This option is only available with software version 9.XX.
Abort any BTM activity. Parameters are not committed.
Parameter 8-46 BTM Transaction Status
Table 523: Parameter 8-46 BTM Transaction Status
8-46 BTM Transaction Status
Default value: [0] Off
Parameter type: Option
Setup: All setups
Conversion index: –
Data type: Uint8
Change during operation: True
Option
Name
Description
[0]*
Off
[1]
Transaction started
[2]
Commit transaction
[3]
Transaction timeout
[4]
Err. non-existing par.
[5]
Err. par. out of range
AU275636650261en-000101 / 130R0334 | 297Danfoss A/S © 2022.12
Parameter Descriptions
VLT AutomationDrive FC 301/302
Programming Guide

Danfoss VLT CANopen MCA 105 Specifications

General

Brand	Danfoss
Model	VLT CANopen MCA 105
Category	DC Drives
Language	English