Danfoss VLT HVAC Drive FC 102 - Page 124

3) Applies for dimensioning of adjustable frequency drive cooling. If the switching frequency is higher than the
default setting, the power losses may increase. LCP and typical control card power consumptions are included. For
power loss data according to EN 50598-2, refer to www.danfoss.com/vltenergyeciency.
4) Eciency measured at nominal current. For energy eciency class, see chapter 7.2 Ambient Conditions. For part
load losses, see www.danfoss.com/vltenergyeciency.
General Specications
VLT
®
HVAC Drive FC 102
122 Danfoss A/S © 08/2014 All rights reserved. MG11F522
77