Danfoss VLT HVAC Drive FC 102 - Field Installation of Options; Installation of Duct Cooling Kit in Rittal Enclosures

533.0
[20.984]
594.8
[23.417] 1727.8
[68.024]
35.5
[1.398]
[21.063]
258.2
[10.167]
199.5
[7.854]
37.7
[1.485]
460.0
[18.110]
994.3
[39.146]
216.5
[8.524]
36.2
[1.425]
281.8
[11.096]
1
130BA841.12
535.0
655.9
25.825
Figure 3.37 Enclosure Size F2
1
130BA843.12
37.7
(1.485)
535.0
(21.063)
35.5
(1.398)
36.2
(1.425)
533.0
(20.984)
597.0
(23.504)
1130.0
(44.488)
1192.8
(46.961)
1925.8
(75.819)
258.5
(10.177)
199.5
(7.854)
2X 460.0
(18.110)
634.7
(24.989)
1265.3
(49.815)
593.0
(23.346)
2X 281.3
(11.075)
2X 216.5
(8.524)
Figure 3.38 Enclosure Size F3
130BA839.10
1
37.7
(1.485)
533 (20.984)
597.0 (23.504)
1130.0 (44.488)
2324.8 (91.528)
535.0
(21.063)
2X 216.5
(8.524)
2X 460.0
(18.110)
634.7 (24.989)
35.5
(1.398)
258.2
(10.167)
199.5
(7.854)
1252.8
(49.321)
994.3
(39.146)
2X 281.8
(11.096)
36.2
(1.425)
1191.8 (46.921)
Figure 3.39 Enclosure Size F4
3.4 Field Installation of Options
3.4.1 Installation of Duct Cooling Kit in
Rittal Enclosures
This section deals with the installation of IP00/chassis
enclosed adjustable frequency drives with duct work
cooling kits in Rittal enclosures. In addition to the
enclosure, a 200 mm (8 in) base/plinth is required.
Mechanical Installation Instruction Manual
MG11F522 Danfoss A/S © 08/2014 All rights reserved. 31
3 3