Danfoss VLT HVAC Series User Manual

10-31 Store Data Values
Option: Function:
Parameter values changed via DeviceNet are not automatically stored in non-volatile memory. Use
this parameter to activate a function that stores parameter values in the EEPROM non-volatile
memory, so that changed parameter values will be retained at power-down.
[0] * Off Deactivates the non-volatile storage function.
[1] Store edit setup Stores all parameter values from the active set-up in the non-volatile memory. The selection returns
to Off [0] when all values have been stored.
[2] Store all setups Stores all parameter values for all set-ups in the non-volatile memory. The selection returns to
Off [0] when all parameter values have been stored.
10-32 Devicenet Revision
Range: Function:
0 N/A* [0 - 65535 N/A] View the DeviceNet revision number. This parameter is used for EDS file creation.
10-33 Store Always
Option: Function:
[0] * Off Deactivates non-volatile storage of data.
[1] On Stores parameter data received via DeviceNet in EEProm non-volatile memory as default.
10-39 Devicenet F Parameters
Array [1000]
No LCP access
Range: Function:
0 N/A* [0 - 0 N/A] This parameter is used to configure the adjustable frequency drive via DeviceNet and build the EDS
file.
3 Parameter Description VLT
®
HVAC Drive Programming Guide
3-116 MG.11.C6.22 - VLT
®
is a registered Danfoss trademark
3

Danfoss VLT HVAC Series Specifications

General

Protection Features	Overcurrent, Overvoltage, Undervoltage, Overtemperature, Short circuit
Communication Interfaces	Profibus, Ethernet
Cooling Method	Forced convection
Ambient Temperature	-10°C to +40°C
Enclosure Rating	IP20, IP21, IP55
Output Voltage	0 - 100% of supply voltage