P I 02 9604 1226 E I sales@danielaappliances.com.au W | danielaappliances.com.au
PAGE 11
If the display flashes alternately with the heat setting
This means that:
• you have not placed a pan on the correct cooking zone or,
• the pan you’re using is not suitable for induction cooking or,
• the pan is too small or not properly centered on the cooking zone.
No heating takes place unless there is a suitable pan on the cooking zone.
The display will automatically turn o after 1 minute if no suitable pan is placed on it.
FINISH COOKING
Touching the heating zone selection
control that you wish to switch o.
Turn the cooking zone o by touching the slider to the left.
Make sure the display shows “0”.
Turn the whole cooktop o by touching the ON/OFF control.
Beware of hot surfaces.
“H” will show which cooking zone is hot to touch. It will disappear
when the surface has cooled down to a safe temperature. It can also
be used as an energy saving function if you want to heat
further pans, use the hotplate that is still hot.
To Next Page
Loading...