Daniela DAN9IM - Timer Control Features; Minute Minder Function; Setting Timer for Zone Control

P I 02 9604 1226 E I sales@danielaappliances.com.au W | danielaappliances.com.au
PAGE 15
WARNING:
1. Other cooking zone will keep operating if they
are turned on previously.
2. The red dot next to power level indicator will illuminate
indicating that zone is selected.
TIMER CONTROL
You can use the timer in two dierent ways:
• You can use it as a minute minder. In this case, the timer will not turn any cooking zone o
when the set time is up.
• You can set it to turn one cooking zone o or more than one after the set time is up.
• The timer maximum is 99 minutes.
Using the Timer as a Minute Minder
If you are not selecting any cooking zone
• Make sure the cooktop is turned on.
Note: you can use the minute minder even if you’re
not selecting any cooking zone.
• Touch timer control, the “ 10 ” will show in the timer
display where touched and the “ 0 ” flashes.
• Set the time by touching the slider control. (e.g. 6)
• Touch timer control again, the “ 1 ” will flash.
• Set the time by touching the slider control (e.g. 9),
now the timer you set is 96 minutes.
• When the cooking timer expires, the corresponding
cooking zone will be switched o automatically.
• When the time is set, it will begin to count down
immediately. The display will show the remaining time
and the timer indicator will flash for 5 seconds.