ENGLISH
12
6.
Parts Required:
2 x Wheel (#35)
2 x Wheel Axle Pin (#G)
2 x Wheel Washer (#F)
2 x Wheel Cotter Pin (#E)
Installation:
• Attach the Wheel to the Support Leg by inserting the wheel axle pin
through the wheel, support leg hole, wheel washer, then secure using
the wheel cotter pin. Repeat installation for the other Wheel.
7.
Parts Required:
2 x Locking Caster Wheel (#34)
Installation:
• Insert each Locking Caster Wheel into the bottom of the two Support
Legs by hand-tightening into the hole. It will secure into the self-
clinching nut. Ensure the Locking Caster Wheel is inserted completely
by ensuring it cannot rotate any further.
• Once all wheels are secure, lock the caster wheels, then using a second
person, carefully lift the grill into an upright position.
IMPORTANT: Re-tighten the support leg screws to ensure they are
completely secure after positioning the grill upright.
8.
Parts Required:
2 x Lid Stopper (#3)
Installation:
• Secure the two lid stoppers onto the top of the main barrel using the
pre-installed screw, locking washer and washer on the top.
7
34
34
6
35
35
8
3
3
To Next Page
Loading...
