Dantherm CDP 50 User Manual

40
EN
Mating Mode
Before use, the DRC1 must be mated with the CDP unit.
This section describes how to mate the DRC1 with the dehumidier.
Mating
Procedure 1. Insert batteries (included)
2.a. The DRC1 will search for the dehumidier 2 min. While searching display will ash at 0,5 Hz
2.b. To enter mating mode on the dehumidier:
- Press and hold both up and down buttons on the dehumidier for 5 seconds -
Note: this must be done while the DRC1 is searching for the dehumidier.
OR: turn the dehumidier O and ON.
3. The dehumidier will send a serial number to the DRC1.
When mating is successful, the radio icon comes on.
4. The dehumidier will conrm connection by showing code “Conn” for 3 seconds
More than one remote control panel can be connected to the dehumidier.
Navigation
ENTER press and hold for 3 seconds to enter user menu setup
UP and DOWN buttons to navigate between icons.
LEFT and RIGHT buttons allows to change set points value 1press = 1unit
ENTER conrms new set point value and automatically switches to next icon/or exits the menu
Press and hold RIGHT for 5 seconds to enter installer menu setup. ( Exit setup menu rst)
When no button is pressed for 10 sec, the DRC1 exits the menu and returns to readings screen
Failed mating If mating fails and is shown in the display and the radio symbol ashes
Reset DRC1 and repeat mating process.
Standard readings
Standard readings when connected:
-Stand by, RH and ºC scale
-Compressor active, dehumidifying symbol on
End
point
End
point
Mating
Press and hold for 10 seconds to reset
the serial number stored in DRC1.

Dantherm CDP 50 Specifications

General

Brand	Dantherm
Model	CDP 50
Category	Dehumidifier
Language	English