Danuser EP6 Hex - Drive Unit Specifications

9
EP6EP10EP15EP20
Minimum Hydraulic Flow 6 GPM 10 GPM 15 GPM 20 GPM
Maximum Hydraulic Flow 15 GPM 20 GPM 30 GPM 35 GPM
Maximum Continuous Operating PSI 3000 PSI 3000 PSI 3000 PSI 3000 PSI
Maximum Auger Diameter 24 inches 30 inches 36 inches 36 inches
Output Spindle 2" Hex or 2" Hex or 2" Hex or 2" Hex or
2-9/16" Round 2-9/16" Round 2-9/16" Round 2-9/16" Round
PSI TORQUE
2000 1270 Ft.-Lbs.
2500 1587 Ft.-Lbs.
3000 1904 Ft.-Lbs.
PSI TORQUE
2000 2465 Ft.-Lbs.
2500 3081 Ft.-Lbs.
3000 3697 Ft.-Lbs.
Drive Unit
Specifications
Torque and output speed specifications are based on
theoretical values and are provided for comparative
purposes only.
PSI TORQUE
2000 1874 Ft.-Lbs.
2500 2342 Ft.-Lbs.
3000 2811 Ft.-Lbs.
Model EP10
Model EP20Model EP15
10 48
12 58
14 68
16 77
18 87
20 97
20 50
24 60
28 70
30 75
32 80
35 87
15 49
18 59
20 65
24 78
28 92
30 98
GPM RPM
GPM RPM
GPM RPM
PSI TORQUE
2000 1014 Ft.-Lbs.
2500 1267 Ft.-Lbs.
3000 1520 Ft.-Lbs.
Model EP6
636
848
10 60
12 73
14 85
15 91
GPM RPM
Operator's Manual Direction Terminology
Front
Rear
Right
Left