Why is the Danuser G20/40 tractor action jerky when the digger is attached?
If your Danuser Tools digger causes jerky tractor action, or the hitch raises and lowers rapidly during transport, adjust the tractor hydraulic system for "position control" rather than "draft" or "load control". If your tractor has this feature, lock the upper link bracket in a fixed position.
What to do if the Danuser G20/40 tractor has difficulty raising the auger?
If your tractor struggles to raise the auger with Danuser Tools, try these solutions: * Attach the lift links to more forward holes in the rockshaft lift arms to decrease the lift range. * Move the lift links to more forward holes in the lower links to decrease travel. * Check the tractor hydraulic system to ensure it raises and lowers to the maximum and minimum heights recommended in your tractor operating manual.
What to do if the Danuser G20/40 Tools digger yoke strikes the boom when the digger is raised?
If the digger yoke strikes the boom when raised, here are a few adjustments to consider for your Danuser Tools: * Attach the front end of the boom to a more forward hole on the upper link bracket. * Attach the lower links to rear forward pivot points. * Lengthen the lower links. * Refer to your tractor operating manual for adjustment of the three-point hitch.
How to fix the front end of the Danuser G20/40 boom contacting the tractor when raised or lowered?
To prevent the front end of the Danuser Tools boom from contacting the tractor when raising or lowering it: * Attach the boom to the tractor through a different hole in the upper link bracket. Upper holes will shorten travel, while lower holes will increase travel. * Refer to your tractor operating manual for adjustment of the three-point hitch. * Relocate or adjust the part of the tractor causing the interference.
Instructions may result in personal injury or death; heed these warnings.
Immediate hazard; failure to obey warning likely results in personal injury or death.
Provides solutions for common issues encountered during installation.
Offers advice for overcoming challenges when digging in tough soil conditions.
Describes a kit to add downward force for difficult digging conditions.
To Next Page
General
