Menus
Press the middle key on left side to access the Main Menu. The first screen will
ask for a numerical password which determines the three levels of menus that will
be displayed: User, Service and Factory.
Note: The User level password is always 0000. The Service level password by
default is also 0000 and may be changed by the installer. The Factory level
password is usually set by the maintenance supervisor to protect from
unauthorized use.
After a password is entered, the Main Menu will appear with “Service” or “Factory”
level indicated at the top right of the screen. Note: These levels will expire if no key
is pressed after 10 minutes. Use the Up or Down key to move the menu of choice
to appear in the center black line. Then press Enter key to access that menu.
The USER level displays the following main menu choices:
A. On/Off
B. Setpoint
C. Clock / Scheduler
E. Historical Data
F. Information
The SERVICE level adds the following menu choices to the user level:
D. Input / Output
G. Network Configuration
H. Calibrate Sensors
I. Manual Control
K. Alarms & Limits
M. Zone Control (only shown if feature is enabled)
The FACTORY level adds the following menu choices to the service level:
J. Factory Settings
L. Configure I/O
To Next Page
Loading...
