MENU J – FACTORY SETTINGS (Factory Level)
Caution: This menu requires the Factory Level password and entry should be
limited to qualified service personnel only. Consult with Data Aire before using
this menu as incorrect settings may lead to equipment malfunctions. The
factory level is automatically cleared when no key is pressed within 5 minutes.
S
y
s
t
e
m
S
e
tt
i
n
g
s
Screen
F
li
p
D
e
l
a
y
:
3s
T
e
m
p
U
n
i
t
s
:
F
a
h
r
e
nh
e
i
t
C
on
t
r
o
l
:
R
e
t
u
r
n
T
e
m
p
O
u
t
S
t
a
t
u
s
:
S
y
s
O
n
Zone
C
on
t
r
o
l
:
Y
e
s
Fan
M
od
e
:
A
u
t
o
m
a
t
i
c
Fan
T
yp
e
:
P
l
u
g
F
a
n
Screen Flip Delay: This determines how quickly the status screens will change.
Adjustment range is “None” (screens do not flip) to 15 seconds with a default
setting of None.
Temperature Units: Displays temperature in Fahrenheit or Centigrade.
Control: The unit will maintain the Return (default) or Discharge temperature;
referred to as the “control temperature”.
Out Status: (not on MiniDAP) This Setting determines what controls the Status
Output relay (DO7). Choices are System On (default setting), Dehumidifier On,
Humidifier On, Compressor On or Reheat On.
Analog Output: (MiniDAP only) Sets the function of the analog output Y2.
Choices are “None” (default setting), Humidifier or CW Valve.
Zone Control: (shown if Zone Control feature is enabled) Selection of “Yes”
(default selection) allows this unit to participate in Zone Control. Selection of “No”
removes Zone Control and the unit will operate independent of the zone.
Fan Mode: (MiniDAP only) Selection of “Automatic” only runs the fan when there
is a call for temperature or humidity control. Selection of “Continuous” (default
selection) runs the fan whenever the system is on.
Fan Type: Is the selection of fan installed. Selections are “Std On/Off” or “Plug
Fan” (default setting) which is a variable speed fan.
To Next Page
Loading...
Need help?
General
