Data Aire dap4 - Run Hours Tracking

30
MENU E – Historical Data continued
Run H ou r s 1 R e s e t v
B l o w e r :
16010
No
C o m p 1 :
4010
No
C o m p 2 :
610
No
C o m p 3 :
000
No
C o m p 4 :
000
No
There are up to three screens that indicate accumulated run hours for any device
that can be installed. Devices that are not installed will remain at zero run hours.
The run hours of each device can be independently reset by choosing “Yes” to the
right of the accumulated run hours.
Caution: Do not reset run hours unless you are replacing the device.
D a il y kwh U s age 1
01 :
23 . 0
08 :
22 . 6
02 :
23 . 2
09 :
22 . 8
03 :
23 . 1
10 :
22 . 3
04 :
22 . 9
11 :
22 . 4
05 :
23 . 2
12 :
22 . 5
06 :
23 . 5
13 :
22 . 8
Note: The power usage screens are only displayed when an optional power meter
is installed and configured in the factory menu.
There are three screens that show the amount of power that was consumed. The
power (in kilowatt Hours) for each of the last 30 days is displayed. Upon
completion (at midnight) of each day, the recorded power of each day is advanced
by one day. (Example: power of a finished day becomes day 01 and the power of
day 01 become day 02 and so on.)
On the third screen the total combined power of the 30 days is displayed. There is
also a selection to reset all power usage records.