AIR-COOLED FLUID COOLER
12 • Air-Cooled Condenser Manual
As a precaution, review the following checklist to ensure proper operation. Failure to meet the
following conditions could result in voiding the warranty:
• Only qualified and experienced service technicians should perform installation and
maintenance on this product.
• Check for any damage.
• Check all wiring connections.
• Equipment damage and personal injury can result from improper piping installation,
leak checking and improper handling.
• This equipment is designed to operate properly and produce rated capacities when
installed in accordance with industry standards.
• System piping must be installed following industry standards for good piping practices.
• System must be thoroughly leak checked before initial charging
• System power supply must meet Voltage Tolerance (see section 4.5).
• All controls and safety devices properly connected per wiring diagram.
• Factory installed wiring must not be changed without written factory approval.
• Additionally, the fluid piping must comply with local code.
• Additionally, the fluid piping must comply with local code.
• It is recommended that the installing contractor provide shutoff valves and unions to
permit easy access to parts for either repair or replacement.
• After piping is completed all joints (and connections) should be leak tested.
To Next Page
Loading...
Need help?
General
