DataCard SD Series Packaging Guide

SD Series Printer Repackaging for Shipment 527403-001 Rev. B
SD Series Printer Repackaging for Shipment
The following procedures are required for preparing the SD series printer unit for
shipment.
1. Press the power button to power off the printer.
The front panel on the printer powers off.
2. Disconnect the network or USB cable (the cable is not required for shipment).
3. Unplug the power cord from the printer.
Power Button

DataCard SD Series Specifications

General

Print Resolution	300 dpi
Print Technology	Dye sublimation
Print Capability	Single- or dual-sided printing
Card Thickness	0.040 inches (0.76 mm to 1.0 mm)
Connectivity	USB, Ethernet
Operating System Support	Windows
Card Input Capacity	100 cards
Card Output Capacity	40 cards
Card Thickness Range	0.040 inches (0.3 to 1.01 mm)
Interface	USB, Ethernet
Operating System Compatibility	Windows, Linux