DataCard SD Series

2 SD Series Printer Repackaging for Shipment
4. Remove the printer supplies.
a. Push down and open the printer swing arm.
b. Remove the supply cartridge from the printer.
c. Unload the print ribbon from the supply cartridge.
d. Replace the supply cartridge in the printer and close the swing arm.
5. Remove the printer from the laminator (SD460 units only).
a. Open the laminator access door and slide the printer locking lever in the
laminator to the left position (unlocked).
b. Disconnect the data cable from the laminator to the printer.
c. Lift the printer off of the laminator and place the printer in a stable position.
d. Close the laminator.
Lock
Unlock