DataCard SD460 - Page 4

4 SD460 SLM Laminating System
SD460 Laminating System Quick Install Guide
b. Secure the laminator to the mounting surface (optional).
Refertotheprinter’sInstallation and Administrator’s
Guide for detailed measurements and instructions.
i. Carefully tip the laminator onto its left side (the side
without the access door). Insert the M6 well nuts
into the bolt-down openings in the bottom of the
laminator.
ii. Returnthelaminatortoitsuprightpositionand
secure the laminator to the mounting surface with
the two M6 screws.