Current Calibration
Help Index
Usual Setting
Setting will depend on the results just measured as part of Check Calibration.
The Purpose of This Step
This is the analysis of the measurements taken for Check Calibration. By comparing
the Current values to the Target values a decision can be made as to whether re-
calibration is necessary.
The Long Answer
Periodically, displays need to be re-calibrated because their underlying hardware
characteristics such as White Luminance will decay over time. As this decay occurs,
the calibration needs to be updated to keep the display performance constant.
Current Calibration displays the current (just measured) values of important
characteristics for the display which are controlled by calibration.
The application will compare the Current values to the Target values and make a
determination as to whether re-calibration is needed at this time. The program will set
the default value of the radio buttons based on this decision.
Further Information
For information such as a list of Frequently Asked Questions and details on all
Datacolor products be sure to visit our website: www.datacolor.com/Spyder3
To Next Page
Loading...
Need help?
General
