Need help?Do you have a question about the Datalogic DRAGON D101 and is the answer not in the manual?
General| Type | Handheld Barcode Reader |
|---|---|
| Scanning Technology | Laser |
| Scan Rate | 35 scans/sec |
| Power Supply | 5 VDC ±5% |
| Connectivity | USB, RS-232, Keyboard Wedge |
| Light Source | Visible Laser Diode |
| Supported Barcodes | 1D |
| Operating Temperature | 0°C to 50°C (32°F to 122°F) |
| Storage Temperature | -20 to 70 °C (-4 to 158 °F) |
| Humidity | 5 to 95% non-condensing |
| Drop Specification | 1.5 m (5 ft) to concrete |
Configure the aiming system timeout using specific barcode commands.
Illustrates connecting the reader to a host via RS232 cable.
Shows connecting the reader using a Wedge interface.
Depicts connecting the reader using Pen Emulation.
Scan the 'RESTORE DEFAULT' barcode to reset all settings.
Details the default serial communication (RS232) parameters.
Details the default keyboard wedge interface parameters.
Defines default trigger, flash, beeper, and aiming spot settings.
Scan code to select the RS232 communication interface.
Scan code to select the Pen communication interface.
Scan code to select the Wedge communication interface.
Configure keyboard transmission mode for Wedge interface.
Select the keyboard type for Wedge interface compatibility.
Set the keyboard nationality for correct data interpretation.
To Next Page