What to do if Datalogic Gryphon GD4200 LED is on but doesn't decode barcode?
If the LED is on, but the bar code does not decode, the reader may not be programmed for the correct bar code type. Check that the reader is programmed to read the type of bar code scanned. Also, verify the bar code label to ensure it is not defaced and try scanning another bar code type. Adjust the distance between the reader and the bar code.
Why is my Datalogic Gryphon GD4200 Barcode Reader not transmitting the decoded barcode to the host?
If the bar code is decoded but not transmitted to the host, the reader may not be programmed for the correct host type. Scan the appropriate host type bar code.
What to do if Datalogic Gryphon GD4200 Barcode Reader LED is on but barcode does not decode?
If the LED is on, but the Datalogic Barcode Reader doesn't decode the barcode, ensure that the imager is programmed to read the barcode type you are scanning. Check the label to make sure it is readable. Try scanning another barcode type. Also, adjust the distance between the imager and the barcode by moving the imager closer or further away.
Why nothing happens when scan button is pulled on Datalogic Barcode Reader?
If nothing happens when you pull the scan button on your Datalogic Barcode Reader, check the system power and ensure the power supply is connected. Also, make sure all cable connections are secure.
How to troubleshoot a Datalogic Barcode Reader that does nothing when the scan button is pulled?
If nothing happens when the scan button is pulled, check the system power and ensure the power supply is connected. Also, ensure all cable connections are secure, as loose interface or power cables could be the cause.
What to do if barcode is decoded but not transmitted to the host on Datalogic Barcode Reader?
If the barcode is decoded but not transmitted to the host from your Datalogic Barcode Reader, ensure the imager is programmed for the correct host type. Scan the appropriate host type barcode.
General| Connectivity | USB, RS-232, Keyboard Wedge, Wand Emulation |
|---|---|
| Scan Pattern | Single Line |
| Humidity | 5% to 95% non-condensing |
| IP Rating | IP52 |
| Type | Handheld |
| Reading Distance | Up to 60 cm / 23.6 in (depending on barcode density) |
| Light Source | LED |
| Power Supply | 5 VDC |
| Supported Barcodes | UPC, EAN, Code 39, Code 128 |
| Operating Temperature | 0 to 50 °C |
| Storage Temperature | -20 to 70 °C |
| Drop Specification | 1.5 m drop to concrete |
| Warranty | 3 years |
To Next Page
