Programming
20 Gryphon™ I GD44XX
Programming
The reader is factory-configured with a set of standard default
features. After scanning the interface bar code from the Inter-
faces section, select other options and customize your reader
through use of the programming bar codes available in the
Gryphon I GD44XX PRG. Check the corresponding features
section for your interface, and also the Data Editing and Sym-
bologies chapters of the PRG.
Using Programming Bar Codes
This manual contains bar codes which allow you to reconfig-
ure your reader. Some programming bar code labels, like the
"Reset Default Settings" on page 20, require only the scan of
that single label to enact the change.
Other bar codes require the reader to be placed in Program-
ming Mode prior to scanning them. Scan an ENTER/EXIT
bar code once to enter Programming Mode; scan the desired
parameter settings; scan the ENTER/EXIT bar code again to
accept your changes, which exits Programming Mode and re-
turns the reader to normal operation.
Configure Other Settings
Additional programming bar codes are available in the PRG to
allow for customizing programming features. If your installa-
tion requires different programming than the standard factory
default settings, refer to the PRG.
Resetting Product Defaults
If you aren’t sure what programming options are in your read-
er, or you’ve changed some options and want your custom fac-
tory settings restored, scan the bar code below to reset the
reader to its initial configuration. Reference the PRG for other
options, and a listing of standard factory settings.
Factory defaults are based on the interface type. Be
sure your reader is configured for the correct inter-
face before scanning this label. See "Selecting the
Interface Type" on page 8 for more information.
To Next Page
Loading...
