Datalogic Magellan 2200VS Installation Instructions

Installation Instructions
Magellan
®
2200VS/2300HS EAS Kit
Remove the scanner from its mounted position and disconnect all cables.
1
Place the scanner face down on an ESD protected surface and detach the...
...Front Enclosure ...Top Enclosure
2
Turn the scanner face up, lift off the Front/Top Enclosure, then remove the Chassis.
3
This kit is available only to qualified modular level service providers. Reference the service
manual for your product to find requirements for ElectroStatic Discharge (ESD) protection and
full details regarding the removal and replacement of parts and assemblies.
These instructions explain how to install the EAS wire in either of two scanner models.
Instructions specific to Magellan 2200VS scanners are shown below on the left side of the page
and Magellan 2300HS scanner instructions are shown on the right.
Lift the scanner straight up and
out of its mount.
Lift off the Top Cover, then
use the Lift Handles to remove
the scanner from the counter.

Datalogic Magellan 2200VS Specifications

General

Decoding standards	-1D + GS1 DataBar, -GS1 DataBar Expanded Stacked, -GS1 DataBar Stacked, -GS1 DataBar Stacked Omnidirectional.
Standard interfaces	USB, RS-232
Dimensions (WxDxH)	152 x 152 x 97 mm
Product color	Gray
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	-10 - 40 °C
Operating relative humidity (H-H)	5 - 95 %

Weight and Dimensions

Weight	1100 g