Datalogic Magellan 9400i Setup Guide

Magellan 9300i/9400i/9800i Setup Guide
A Global Payments Company Page 9
Additional Programming Options
The Magellan 9300i can be programmed to read UPC-A
and UPC-E barcodes per your specific requirements.
UPC-A Barcode Options
First-Digit Capture
1 Scan this barcode to enter programming mode. After
scan, the green light on the top of the scanner/scale
will flash, indicating the device is in programming mode.
2 Enable/disable first-digit capture with these barcodes:
 To enable scanning of the first digit of UPC-A barcode numbers, scan this barcode and wait for the
double beep to confirm success.
 To disable scanning of the first digit of UPC-A barcode numbers, scan this barcode and wait for the
double beep to confirm success.
3 To finalize first-digit capture configuration, scan this barcode. After scan, the device will reboot and
the green lights will stop flashing, indicating the device has exited programming mode.

Datalogic Magellan 9400i Specifications

General

Standard interfaces	USB
Connectivity technology	Wired
Type	Built-in bar code reader
Sensor type	Linear
Scanner type	1D/2D
Light levels (direct sunlight)	0 - 86080 lx
Linear (1D) barcodes supported	GS1 DataBar Expanded, GS1 DataBar Omnidirectional, JAN, U.P.C.
2D (matrix & stacked) barcodes supported	Aztec Code, Data Matrix, Micro QR Code, QR Code, Small Aztec Code
Input voltage	100 - 240 V
Input frequency	50 - 60 Hz
Power source type	AC
Power consumption (standby)	11 W
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	10 - 40 °C
Operating relative humidity (H-H)	5 - 95 %
Product color	Black, Grey
Housing material	-
Sustainability certificates	RoHS

Weight and Dimensions

Depth	102 mm
Width	401 mm
Height	130 mm
Weight	- g