Datalogic Matrix 410N User Manual

MATRIX N FAMILY HOST MODE PROGRAMMING
12
3
3.2.9 Get Device Information
The Matrix get device information command must have the following format:
GET_INFO <LF>
If the sequence is correct, the device confirms with the following message:
ACK Device Information <LF>
If programming contents are wrong (i.e. a typing error) or due to a transmission error, the
device replies with the following message:
NACK <LF>
After transmitting the reply message, the device then waits for another programming string or
the exit from host mode programming command.
3.2.10 Send Images
For configurations that allow Image Saving – Send Image On: Demand, it is possible to
start the FTP images transfer from the device to an FTP Server through this command.
The Matrix send images command must have the following format:
SEND_IMAGES<space><NodeNumber>[<space><IdStart>][<space><IdStop>] <LF>
where:
SEND_IMAGES:
The programming command (all caps).
NodeNumber:
(mandatory)
Specifies the node number (0=Master, 1 to 31=Slaves).
The asterisk character ‘*’can be used to send a broadcast command. In
this case the Master and all Slaves will start to transfer images to the
FTP Server.
IdStart:
(optional)
The pack/phase number from which image transfer begins.
IdStop:
(optional)
The pack/phase number from which image transfer ends.
NOTE: If the optional parameters are omitted, the entire image buffer of the
device (or devices) will be sent.

Datalogic Matrix 410N Specifications

General

Brand	Datalogic
Model	Matrix 410N
Category	Laboratory Equipment
Language	English