N
Natalie HernandezAug 2, 2025
What to do if the LED is on, but the Datalogic Heron HD3430 bar code does not decode?
- RRenee RayAug 2, 2025
If the LED is on but the Datalogic Laboratory Equipment isn't decoding the barcode, there might be a few reasons. First, the imager may not be programmed to read that specific type of barcode; make sure it's set up correctly. Second, the barcode label itself might be damaged or unreadable, so check for any defects and try a different barcode. Finally, the distance between the imager and the barcode could be off; try moving the imager closer or further away.