Exit and Save Configuration
Divide Code into Fields
Read one number in the range 1 to 5 to divide the code into fields.
Each code field length can be set by either:
a) defining a field separator character to be found in the code itself
OR BY
choose to discard the code separator character or include it as the last cha
field.
b)
defining a match character to be found consecutively repeated in the code itself
case the field ends with the first character that does not match.
c) specifying a specific character length
up to the maximum of 99 characters.
d) selecting the last field as variable length
You must define the same number of fields as selected in step 5, including fields that will
not be transmitted.
To Next Page
Loading...
Need help?
General
