Datalogic PowerScan D8300 User Manual

POWERSCAN
®
D8330/M8300/M8300-DK
34
5.
Read the BC-8060 restore default code:
Restore BC-8060 Default
Ì$+RX0$-qÎ
6.
Read the desired Enable Network code.
Enable RS-485 Master
Ì$+RZ2$-ÇÎ
Enable RS-485 Slave
Ì$+RZ1$-~Î
END of procedure.
For Host Master Network Layouts (see par. 3.2), The network configuration
parameters can be changed through STAR-Link™ software running on the PC.
Star-Link™ software can be downloaded for free from the web site:
www.scanning.datalogic.com.
For BC-8060 Master Network Layouts (see par. 3.2), The network configuration
parameters can be changed either through the Datalogic Aladdin™ configuration
software running on the PC or by reading the barcode selections in the Network
section of this manual starting on page 64. If using configuration barcodes, it is
advised to completely configure the cradles before reconfiguring the PowerScan
®
M8300 reader (see below).
After completing the BC-8060 cradle c
onfiguration and
connections in the network, you must reconfigure the
PowerScan
®
M8300 reader using the STAR-System™ procedure
in par.
4.6.
NOTE

Datalogic PowerScan D8300 Specifications

General

Brand	Datalogic
Model	PowerScan D8300
Category	Barcode Reader
Language	English