Exit and Save Configuration
TERMINATOR
one character terminator
two character terminator
three character terminator
four character terminator
five character terminator
six character terminator
seven character terminator
eight character terminator
After selecting one of the desired Header codes, read the character(s) from the HEX table.
Valid characters are in the range 00-FE. For Wedge and USB-KBD interfaces, it is also possible
to read the Special Key(s) on page 74.
Example:
+ 0D + 0A = Terminator CR LF
For more details see par. 5.4.1 and par. 5.4.2.
To Next Page
Loading...
Need help?
General
