16 PowerScan® PBT7100 Cordless Imaging Reader
• The reader may not be programmed to output your barcode data properly. For example,
you scan “12345” and the host displays “A12345B.” Reprogram the reader with the
proper Data Editing selections. Reference the PRG.
• The reader won’t read your barcode at all.
• Scan the part number barcode on the back of this manual or other known-good barcode
samples. If the reader reads sample barcodes, check that your target barcode is readable.
• Verify that your barcode symbology is enabled. See the PRG.
• If you aren’t sure what programming options have been set in the reader, or if you want the
factory default settings restored, go to the
Resetting the Standard Product
Defaults section of this manual and scan the standard factory default settings barcode.
• The reader sounds other than a standard “Good Read” beep followed by an “Acknowledge
1
”
beep when reading a barcode (indicating the barcode has been read and properly transmit-
ted).
• Verify the reader is linked to and within range of its Base Station.
1. Typically, both of these beep indications are active in the reader. To enable/disable these
indications, reference the PRG.
To Next Page
Loading...
