Quick Reference Guide 7
Getting Started
Installing the Battery Pack
NOTE
To charge the Battery Pack, See “Battery Pack Charging and
Maintenance” on page 11.
Datalogic recommends annual replacement of rechargeable bat-
tery packs to ensure maximum performance.
WARNING
Do not discharge the battery using any device except for the reader.
When the battery is used in devices other than the linear imager, it
may damage the battery or reduce its life expectancy. If the device
causes an abnormal current to flow, it may cause the battery to
become hot, explode or ignite and cause serious injury.
Lithium-ion battery packs may get hot, explode or ignite and cause
serious injury if exposed to abusive conditions. Be sure to follow the
safety warnings listed below:
• Do not place the battery pack in fire or heat.
• Do not connect the positive terminal and negative terminal of
the battery pack to each other with any metal object (such as
wire).
• Do not carry or store the battery pack together with metal
objects.
• Do not pierce the battery pack with nails, strike it with a ham-
mer, step on it or otherwise subject it to strong impacts or
shocks.
• Do not solder directly onto the battery pack.
• Do not expose the battery pack to liquids, or allow the battery
to get wet.
In the event the battery pack leaks and the fluid gets into your eye,
do not rub the eye. Rinse well with water and immediately seek med-
ical care. If left untreated, the battery fluid could cause damage to
the eye.
To Next Page
Loading...
Need help?
General
