Parts of the Scanner
Quick Reference Guide 3
Parts of the Scanner
Scanning Modes
The scanner can operate in two modes:
• Trigger Single Mode - trigger button must be pressed to
emit the laser in order to a scan barcode.
or
• Stand Mode - scanner laser is in constant on state and no
trigger button press is required to scan a barcode.
To toggle between modes, scan the “Toggle Scan Mode” barcode
below.
Depending upon which mode the scanner currently is in, scan the
“Toggle Scan Mode” to switch from Trigger Single to Stand, or
from Stand to Trigger Single Mode.
While in the Stand mode of operation, if the scanner has not been
used for several minutes it will shift to low power operation, sig-
nalled by a narrowing of the scanning beam. When in low power
mode, the scanner will respond to a barcode and come back to nor-
mal Stand Mode operation upon seeing/reading the label.
If the scanner has been idle for an extended configurable period
1
,
it will timeout, then enter sleep mode with the scanning beam
turned off. To wake the scanner from sleep mode, press the trigger
button.
1. See the following topic Stand Mode Timeout Period.
To Next Page
Loading...
Need help?
General
