Software Installation
The Vision software (driver and application) is installed by inserting the DVD that was shipped with your card into your DVD
ROM drive. The installation process should start automatically.
Should the DVD fail to autorun use Explorer to browse the DVD, locate then double click on install.exe le e.g. d:/install.exe
and click on Install Software… and follow the installation wizard instructions as prompted.
We recommend that you download the latest Vision software from the Datapath website: www.datapath.co.uk
Also available on the Datapath DVD:
• The Release Notes - The release notes contain the latest information on the VisionSC-UHD2.
• Installation instructions.
• Release history.
• Known problems.
• Troubleshooting.
• The application Help File - Instructions on how to use the application. The help le is in d:/software/vision.chm. The help
le must be located on the local machine to view its content.
We are continuously developing the technology used within our product ranges and from time to time we may issue rmware
upgrades. The VisionSC-UHD2 cards allow rmware upgrades to be completed on site rather than returning the card to
Datapath. To perform the upgrade, follow the step-by-step instructions provided by the upgrade application.
In the unlikely event that something goes wrong during the upgrade process (e.g. System power outage) the card has a back-up
facility to enable the software to automatically detect and reprogram the upgrade.
Firmware Upgrades
7
To Next Page
Loading...
Need help?
General
