Datavan G-615 - Page 3

3
,IWKHUHLVDQ\RIWKHIROORZLQJVLWXDWLRQDULVHQRWLI\DTXDOL¿HGVHUYLFHWHFKQLFLDQ
immediately:
¸The power cord or plug is damaged.
¸Liquid has been spilt on to the equipment.
¸The equipment has been dropped and damaged.
¸The equipment does not function normally.
Do not block any ventilation openings to prevent the equipment from overheat.
Do not leave the equipment in a non air-conditioned environment where the storage
temperature may go above 70°C (158°F), as this can cause damage to the equipment.
Maintenance
Gently wipe screen with a clean soft hair lens brush, or a lint-free cloth.
Do not apply pressure to the screen while cleaning.
Do not spray any liquid directly onto the screen or the casing of the terminal.
Chemical cleaners have been reported to cause damage on the screen of the terminal.
Warning and Attention
7KHWHFKQLFDOGHVFULSWLRQVDQGVSHFL¿FDWLRQVRIWKHHTXLSPHQWDUHVXEMHFWWRFKDQJHZLWKRXW
notice.
For safety reasons, wear gloves when assembling the product.
Risk of explosion if battery is replaced by an incorrect type.
Dispose of used batteries according to the instructions.
Patent
Patent pending.
CE Statement
A Class III equipment with an enclosure made of HB material and using a non-special
connector for the a.c./d.c. input has to have a marking stating the following: “Use only
power supplies listed in the user instructions” or “For applicable power supplies see user
instructions”. This statement shall also be in the user-instructions.
If product with laser module, the class of laser should be mentioned. The warning as
attachment.